Forum

scrog · Joined: 20 Jul 2007 Posts: 21

how do you make a loop cut ?

craouette · Posted: Wed Oct 20, 2010 5:51 am Post subject:

In edge toolbox, select a ring (popup menu or 'R' shortkey) and then use the 'Cut & join' tool... that's it!

Craouette

scrog · Joined: 20 Jul 2007 Posts: 21

That is what i thought it would be, but it does not work.

craouette · Posted: Thu Oct 21, 2010 7:15 am Post subject:

What is not working?
The ring select work only on quad faces... may be that's the problem?
Can you eventually post/send me images of the problem?

craouette

craouette · Posted: Thu Oct 21, 2010 7:24 am Post subject:

Here are some screenshots:
Select an edge:

Select a ring:

Use the cut and join tool:

Is it what you want to do?

Craouette

scrog · Joined: 20 Jul 2007 Posts: 21

I downloaded the link you sent be and now cut and join works fine.
Thank you

craouette · Posted: Thu Oct 21, 2010 4:50 pm Post subject:

Cool!!!

scrog · Joined: 20 Jul 2007 Posts: 21

I will try to recruit some programmers to work on A3d with you, if that is ok.
I am liking the potential of A3d very much.

craouette · Posted: Fri Oct 22, 2010 4:42 am Post subject:

No pb for me.

foff44 · Posted: Mon Oct 25, 2010 10:10 am Post subject:

I have installed the programme and following this particular thread,
Is there a way to get tool-tips to show ?

is there a manual I can download, I downloaded the ppmodeler pdf but its not relevant for this programme.?

last one,
I selected a face, looped it but following your reply on another thread , when I Shift Click it doesn't deselect

thanks
_________________
Just do it, It might be fun.

craouette · Posted: Mon Oct 25, 2010 10:35 am Post subject:

With the popup menu, available right clicking in a view.
The tools tips are displayed in the status bar, at the bottom of the window.
Right clicking on a tool button also shows the tips.

The manual is old (at best Sad

), but not so irrelevant...

Craouette